Hama Racemachine Mode D'emploi page 9

Quadrocopter/rc-car 2-en-1
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Turning left or right
• To turn the drone left, move the left control lever (2)
on the remote control to the left.
• To turn the drone right, move the left control lever (2)
on the remote control to the right.
Loops – only for experienced pilots!
Note – Loops
• The battery of the drone must be fully charged to be
able to use the loop function.
• Fly the drone at an altitude of approximately 3 m.
• Press and hold the Loop button (8).
• Move the right control lever (9) to control the loop
direction.
11
Left control
Left control
Right control
7.2 Tweaking the control (trimming)
Note – Trimming
• The drone should be smooth and stable in the air,
and should fly only in the direction that is set using
the control.
• After a certain time, there may be slight directional
tilts even though the control levers are in the resting/
neutral position.
• These directional tilts can be eliminated by trimming
the control.
Left/right
• If the drone continually tilts to the right during the flight,
briefly push the Tweaking button (11) to the left. Repeat
this step until the drone is aligned.
• If the drone continually tilts to the left during the flight,
briefly push the Tweaking button (11) to the right.
Repeat this step until the drone is aligned.
Forwards/backwards
• If the drone continually tilts forwards during the flight,
briefly push the Tweaking button (10) downwards.
Repeat this step until the drone is aligned.
• If the drone continually tilts backwards during the flight,
briefly push the Tweaking button (10) upwards. Repeat
this step until the drone is aligned.
7.3 Actual Direction mode
Note – Actual Direction mode
• If Actual Direction mode is activated, the control of
the drone when sending commands is guided by the
position of the pilot.
• If you move the right control lever (9) upwards/
downwards, the drone flies away from you / towards
you.
• If you move the right control lever (9) to the left/right,
the drone flies left/right.
• The flight direction and position of the drone is
irrelevant in this mode.
• Make sure that you remain in the position that you
take during calibration with the remote control.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

00126853

Table des Matières