Symbols Used; Transmitter Battery; Safety And Environment - Fender FWG 2020 Mode D'emploi

Thank you . . .
. . . for purchasing a Fender product. This manual contains important
instructions for setting up and operating your equipment. Please take
a few minutes to read the instructions below carefully before operat-
ing the equipment. Please keep the manual for future reference. We
hope you enjoy using your system!

Symbols Used

The lightning flash with arrow point in an equilateral trian-
gle means that there are dangerous voltages present
within the unit.
The exclamation point in an equilateral triangle on the
equipment indicates that it is necessary for the user to
refer to the User Manual. In the User Manual, this symbol
marks instructions that the user must follow to ensure
safe operation of the equipment.
i
Important Note

Transmitter Battery

• The display on your bodypack transmitter indicates the mini-
mum remaining battery capacity in transmitter operating hours.
• To ensure an accurate readout, do not use any batteries other
than new, high quality AA size (LR6) alkaline dry batteries from
Duracell or Energizer,
- AA size (FR6) lithium batteries,
or
- High quality AA size NiMH rechargeable batteries with a capacity
of 2100 mAh or higher.
- In the "BAT.TYP" menu, select the battery type you inserted
("LR6", "FR6", "HR6 (NiMH)) or automatic battery detection mode
("AUTO").
- In "AUTO" mode, using weak or very old batteries may cause
incorrect capacity indications. In this case, select the battery type
manually.
• Since the chemical parameters of batteries take some time to
stabilize, the system may correct the battery indication (type
and remaining capacity) about 10 to 30 minutes after switching
power to the transmitter on.
• Lithium batteries have a life of up to 14 hours. The display, how-
ever, will only indicate a maximum of 10 hours. With new lithium
batteries, the display will constantly indicate "10h" during the
first four operating hours.

Safety and Environment

Safety
• Do not expose it to direct sunlight, excessive dust, moisture,
rain, mechanical vibrations, or shock.
• Do not spill any liquids on the equipment and do not drop any
objects through the ventilation slots in the equipment.
Safety
• The equipment may be used in dry rooms only.
• Before connecting the equipment to power, check that the AC
mains voltage stated on the included power supply is identical
to the AC mains voltage available where you will use the equip-
ment.
• Operate the equipment with the included power supply with an
output voltage of 12 VDC only. Using adapters with an AC output
and/or a different output voltage may cause serious damage to
the equipment.
• The equipment should be opened, serviced, and repaired by
authorized personnel only. The equipment contains no user-ser-
viceable parts.
• Operate the equipment off voltages between 90 VAC and 240
VAC only. Using a different power voltage may cause serious
damage to the unit!
• If any solid object or liquid penetrates into the equipment, shut
down the sound system immediately. Disconnect the power ca-
ble from the power outlet immediately and have the equipment
checked by Fender service personnel.
• Do not place the equipment near heat sources such as radiators,
heating ducts, or amplifiers, etc. and do not expose it to direct
sunlight, excessive dust, moisture, rain, mechanical vibrations, or
shock.
• To avoid hum or interference, route all audio lines, particularly
those connected to the inputs, away from power lines of any
type. If you use cable ducts or conduits, be sure to use separate
ones for the audio lines.
• Clean the equipment with a moistened (not wet) cloth only. Be
sure to disconnect the equipment from the power outlet before
cleaning the equipment! Never use acidic or scouring cleaners or
cleaning agents containing alcohol or solvents since these may
damage the enamel and plastic parts.
• Use the equipment for the applications described in this manu-
al only. Fender cannot accept any liability for damages resulting
from improper handling or misuse.
Environment
• Be sure to dispose of dead batteries as required by local waste
disposal rules. Never throw batteries into a fire (risk of explosion)
or garbage bin.
• The packaging of the equipment is recyclable. Dispose of the
packaging in an appropriate container provided by the local
waste collection/recycling entity and observe all local legislation
relating to waste disposal and recycling.
• When scrapping the equipment, remove the batteries, separate
the case, circuit boards, and cables, and dispose of all compo-
nents in accordance with local waste disposal rules.
1