Starting Setup - Insignia NS-27RTV Guide De L'utilisateur

Connecting the television to a DTV receiver or
set-top box
If you connect a DTV receiver/set-top box,
connect your television to it by using a
component video cord.
To Audio
OUT
Audio
cord (not
supplied)
To COMPONENT
IN
Using an AV amplifier with built-in digital surround
If you are using an amplifier with built-in digital
surround sound as follows, you can enjoy
various audio systems including Dolby Digital
Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby
Digital decoder as shown below.
Coaxial Digital
Audio Output
Coaxial
digital
cable
(not
supplied)
to
Coaxial
Digital
Audio
Input
AV Amplifier with
Surround Speaker
built-in digital
(Left)
surround decoder
as listed above
When you make the connection above, on
Note
the AV amplifier, do not set DOLBY DIGITAL
to DOLBY DIGITAL ON. If you do, a loud
noise emits from the speakers possibly
causing damage to your hearing or to the
speakers.
Connecting the television to a camcorder
To play back from a camcorder, connect the
camcorder to the television as shown.
8
To Component
OUT
Video cord
(not supplied)
Front
Speaker
(Left)
Subwoofer
Front
Speaker
(Right)
Center
Speaker
Surround
Speaker
(Right)
www.insignia-products.com
To Audio/Video
OUT
Audio/Video cord
(not supplied)
Connecting the television to a video game console
The television can also be used as a display
device for many video games. However, due to
the wide variety of signals generated by these
devices and subsequent connection variations
required, they have not all been included in the
suggested connection diagrams. You'll need to
consult each component's owner's manual for
additional information.
Video
Game
Console
To Audio/Video
OUT
Audio/Video cord
(not supplied)

Starting setup

The STARTING SETUP menu appears the first
time you turn on the television, and helps you
select the menu language, specify the
TV/CABLE setting, and program your channels
automatically.
To complete initial television setup:
1 Make sure that the antenna or cable
television system is connected.
2 Press POWER. The starting setup function
begins and the language setup menu
appears on the screen.
3 Press or
language, then press ENTER.
4 Press or to select TV or CABLE, then
press ENTER.
5 Press or
ENTER.
If you select CANCEL and press ENTER, the
STARTING SETUP stops and changes to the
television screen.
The AUTO SETUP starts. After the
STARTING SETUP is completed, the
television channel appears on the screen.
Depending on the reception condition, it may
take approximately ten minutes to complete
memorizing digital cable channels.
Note If you press EXIT in the process of AUTO
SETUP, the STARTING SETUP stops and
changes to the television screen.
NS-27RTV 27-inch Color TV
Front of the TV
Front of the TV
to select your desired
to select START, then press