Preparing To Set Up Your Tv; Unpacking And Setup; Power Source - Insignia NS-30HTV Guide De L'utilisateur

• If your TV does not operate normally by
following the operating instructions, adjust
only those controls that are covered by
the operating instructions, because
improper adjustment of other controls
may result in damage and will often
require extensive work by a qualified
technician to restore your TV to its normal
operation.
• If your TV has been dropped or damaged
in any way.
• When your TV exhibits a distinct change
in performance, this indicates a need for
service.
• Replacement Parts–When replacement
parts are required, be sure the service
technician uses replacement parts specified
by the manufacturer that have the same
characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock, injury to persons or other
hazards.
• Safety Check–Upon completion of any
service or repairs to your TV, ask the service
technician to perform routine safety checks to
determine that your TV is in correct operating
condition.
• Heat–Place your TV away from heat sources
such as radiators, heat registers, stoves, or
other products (including amplifiers) that
produce heat.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies
that the cable ground should be connected to the grounding
system of the building as close to the point of cable entry as
practical.
A NOTE ABOUT RECYCLING: Batteries should never be
thrown away or incinerated but disposed of in accordance
with your local regulations concerning chemical wastes.
CAUTION:
CAUTION: TO PREVENT ELECTRIC SHOCK DO
NOT USE THIS POLARIZED PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
.
EXPOSURE
FCC WARNING:
Changes or modifications not expressly
approved by the party responsible for compliance with the
FCC Rules could void the user's authority to operate this
equipment.

Preparing to set up your TV

Unpacking and setup

Your TV carton should contain:
•
•
•
If you need to replace these accessories, call
our help line mentioned in the Warranty section
of this guide.
Depending on your antenna system, you may
need different types of combiners (mixers) or
separators (splitters). Contact your local
electronics store for these items.
Carefully remove all the components from the
carton and verify that you have all the necessary
components before you dispose of the carton.
•
•
•
•

Power source

Use the polarized AC line cord provided for
operation on AC power. Insert the AC cord plug
into a standard 120 V 60 Hz polarized AC outlet.
If you cause a static discharge when touching
your TV and your TV fails to function, unplug
your TV from the AC outlet and plug it back in.
Your TV should return to normal operation.
Warning
www.insignia-products.com
30" Wide Flat Digital TV
User Guide
Remote control unit
Remove all packing materials from the
individual components.
Do not remove any labels or stickers on the
back panel of your TV.
Place your TV in the location you want. Your
TV is designed to be used on a level, stable,
flat surface, such as a table, desk, shelf, or
stand convenient to a power outlet, out of
direct sunlight, and away from sources of
excess heat, dust, moisture, or vibration.
Unwind the AC power cord on the back of
your TV and extend the cord to its full length.
• The system uses a polarized AC plug with
one wide blade and one narrow blade. The
plug will only fit into matching polarized
power outlets. This is a safety feature to
reduce the possibility of electric shock. If
the plug will not fit in your power outlets,
you probably have outdated,
non-polarized outlets which should be
changed by a qualified, licensed
electrician. Do not file the wide blade on
the plug or use an adapter to make the
plug fit into your outlet. This defeats the
safety feature and could expose you to
electric shock.
• Never connect the AC cord plug to other
than the specified voltage (120 V 60 Hz).
Use the attached power cord only.
3