Wall Installation - tomado TMA7001W Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
INSTALLATION OF THE WINDOW SEAL SET
The window seal set is suitable for many windows. Installation of the window seal set is usually horizontal or vertical. There is little difference between the methods of installation. It ensures
that you are able to hang the discharge hose to the outside, without hot air flowing into the room again or having problems with insects.
• Attach the supplied double-sided sealing tape on the window frame and the window in accordance with one of the drawings below that is similar to your situation. Cut away excess tape.
• Then place the window seal set in the openings of the window.
• If necessary, attach the safety bracket with screws, so that it is impossible to open the window.
• Attach the connector to the end of the discharge hose on the window seal set.
Situation 1
sealing tape
Situation 2
sealing tape

WALL INSTALLATION

• Drill a 125 diameter hole in the wall, for the wall outlet with valve.
• Fasten the wall outlet with the provided screws and plugs.
• Attach the end of the discharge hose with the wall outlet connector to the wall outlet.
• Close the valve of the wall outlet when the appliance is not being used.
plugs
wall outlet
with valve
bracket with screws
window seal set
window seal set
max. 120 cm.
min. 30 cm.
bracket with
screws
EN - 20

Publicité

Table des Matières
loading

Table des Matières