Maintenance And Inspection - Metabo HPT G 12SA3 Instructions De Sécurité Et Mode D'emploi

English
Wrench
Wheel nut
Depressed
center wheel
Wheel washer
Wheel guard
Spindle
Fig. 5

MAINTENANCE AND INSPECTION

WARNING
Be sure to switch power OFF and disconnect the plug from the receptacle during maintenance and
inspection.
Using cracked, deformed or damaged wheels can lead to wheel breakage and resulting serious
injury.
1. Replacing the depressed center wheel
Replace the depressed center wheel when it has
been worn out to about 2-3/8" (60 mm) in external
diameter. Confi rm that there is no crack or any damage
to the depressed center wheel. If there is a crack or a
transformation in the wheel, replace it immediately.
2. Inspecting the screws
Regularly inspect all screws and ensure that they
are fully tightened. Should any of the screws be
loosened, retighten them immediately.
WARNING
Using this grinder with loosened screws is extremely
dangerous.
3. Confi rm that there is no damage in the wheel guard,
the electrical cord and the housing, etc.
Check that the on/off switch operates normally.
4. Inspecting the carbon brushes (Fig. 6)
The motor employs carbon brushes which are
consumable parts. Replace the carbon brush with
a new one when it becomes worn to its wear limit.
12
Tighten
2.
Push button
NOTE
CAUTION
Tighten the wheel nut securely and confi rm that
the depressed center wheel does not wobble.
Disassembly
To remove the depressed center wheel, simply
reverse the above-mentioned procedure.
Always keep carbon brushes clean and ensure that
they slide freely within the brush holders.
No. of carbon brush
Wear limit
88
0.67" (17mm)
Fig. 6
CAUTION
Using this grinder with a carbon brush which is
worn in excess of the wear limit will damage the
motor.
Use metabo HPT carbon brush No. 88 indicated in
Fig. 6.
0.24" (6mm)