Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Accessories
Check the following accessories are included.
< > shows the quantity.
Terminal display label <1>
(Attach this label to the
back cover.)
Note
●
Dispose of the packaging material properly after the
product is taken out.
●
Keep small parts out of reach of infants.
Terminals
Note
●
Use a 5CFB cable or equivalent to connect to the SDI
terminal.
●
When the LCD display is in standby mode, the active-
through output will be stopped.
●
SLOT1 terminals are assigned to 3G-SDI1 and
3G-SDI2, and similarly SLOT2 terminals to 3G-SDI3
and 3G-SDI4.
●
If CRCC error (page 17) occurs, check the cable to
use.
12
English
Screw <4>
●
Keep the screws for
spare. Use them if the
slot cover mounting
screws are lost.
●
Tightening torque
guideline: 60 N·cm
or less
Input terminal (BNC)
3G-SDI/HD-SDI/SD-SDI input
terminal
Active-through output terminal
(BNC)
Directly outputs each SDI input.
Replacing the
terminal board
This terminal board supports SLOT NX. (Cannot be
mounted to displays compatible with SLOT2.0.)
For projector
Please refer to the operating instructions of the
projector.
For flat panel display
The replacement instruction below is based on the
flat panel display LQ series as an example.
Please contact our designated service department
for replacement of the terminal board of the flat panel
display.
Follow the steps below.
Note
●
Be sure to turn off the display unit and connected
devices, remove the power plug from the socket, and
disconnect the cables from the display.
●
When attaching/removing the terminal board, do not
allow the metal to damage the back cover or display
label.
1
Remove the slot cover or
terminal board from the
display unit.
Remove the slot cover
mounting screws (4) from
the rear of the display unit.
When the terminal board
has been attached, hold the
handle of the terminal board
and pull it out in the arrow
direction.
2
Attach the terminal board.
1) Insert the board along
the groove and push in to
the end.
2) Fix the terminal board
with four screws removed
in the order of
,
1
.
4
Note
●
4 screws (2 screws at right and left ends
respectively) are tightened for each slot. Thus, the
number of screws required differs depending on
the number of slots for insertion. Check carefully
that the screws are firmly tightened.
2
4
3 1
,
,
3
2
Publicité
Table des Matières
