Transporting And Storing - Milwaukee M18 FUEL 2733-20 Manuel De L'utilisateur

24. Trigger
25. Trigger lock
26. Cut-line indicator switch (not shown)
37
36
CAPACITIES
Miter Cuts
Max Height ..................................................... 2.2"
Max Width at 0° Miter...................................... 8.3"
Max Width at 45° Miter .................................. 5.8"
Bevel Cuts
Max Height at 0° Bevel ................................... 2.2"
Max Height at Left 45° Bevel .......................... 1.6"
Max Height at Right 45° Bevel ....................... 0.8"
Compound Cuts (45° Miter and 45° Bevel)
Left .............................................. 5.9" W at 1.6" H
Right ............................................ 5.9" W at 0.8" H
Workpiece Vertical Against Fence
0° Miter / 0° Bevel ........................ 3.6" W at 0.9" H
Left 45° Miter / 0° Bevel ............... 3.6" W at 0.8" H
Right 45° Miter / 0° Bevel ............ 3.6" W at 0.7" H
27. Dust chute
28. Dust bag
29. Slide rail lock
24
35
34
Always lock the saw head and slide rails before
transporting and storing the tool. Only carry tools by
the carrying handles.
Saw Head
To lock, press and hold down the saw head and then
push in the lock-down pin.
To unlock, press and hold down the saw head and
pull out the lock-down pin. Raise the saw head.
Slide Rails
To unlock, loosen the slide rail lock by turning it
counterclockwise.
To lock, slide the saw head forward and tighten the
slide rail lock by turning it clockwise.
To prevent the tool from sliding, falling or tipping
from a raised work surface during operation, the saw
should be mounted to a supporting surface such as
a level, sturdy work table, bench, or miter saw stand.
Position the saw and workbench to allow adequate
room for cross-cutting long workpieces. To mount
the saw to a flat surface, insert fasteners through
the holes in the corners of the saw base and secure.
Follow manufacturer instructions when mounting to
a miter saw stand.
5
30. Bevel knob
31. 0° stop pin
32. Hand stop
33. Wrench storage (not shown)
34. 6 mm Hex Wrench
35. Workpiece clamp sockets (2)
36. Spindle lock
25
37. Handle
26
27
32
33
ASSEMBLY

Transporting and Storing

Mounting the Miter Saw
28
29
30
31