Denon Professional DN-508MX Guide D'utilisation page 7

Operation
After setting up and powering on DN-508MX and your connected devices, you can start using
DN-508MX.
Important: The default administrator password is adminpwd. There is no default operator
password.
Navigating the Display and Menus
To switch between the Menu and the settings of the current zone, press Menu.
To move through the options in the display, turn the Volume/Sel knob.
To select an option in the display, press the Volume/Sel knob.
To return to the previous screen, press Mute/Back.
Managing Zones
To select a zone, press the desired output selector. The currently selected one will be lit
amber. The source selectors of any audio sources that are assigned to that zone will light up
amber, as well.
To assign or unassign an audio source to a zone, select it (described above), and then
press the desired source selectors. The source selectors for currently assigned audio
sources will be lit amber.
To set the volume level of a zone, select it (described above), and then turn the Volume/Sel
knob.
Using the Web Interface
Important: To use the web interface, both DN-508MX and your computer must be connected
to the same network. We recommend connecting the Ethernet port and your computer to a
network switch or router using standard Ethernet cables. If your computer is wirelessly
connected to your router, connect just DN-508MX to that router. Alternatively, connect DN-
508MX's Ethernet port directly to a computer using an Ethernet crossover cable.
Important: Visit denonpro.com
complete instructions on how to use the DN-508MX web interface.
To open the DN-508MX web interface, on your computer, open a web browser.
•
If DN-508MX is connected directly to a computer, go to
browser. You may have to enter the operator password. There is no default password,
but if you have already set one, you will have enter it here.
•
If DN-508MX is connected to a network switch or router (wirelessly or wired), use the
Menu button and the Volume/Sel knob to do the following:
i. Press Menu to enter the Menu.
ii. Select and enter 2. System, then Ethernet, then IP Address, and then the Auto
setting (you may have to enter the administrator password).
iii. Set Auto to On, and select Yes when asked if you want to apply the change.
iv. When the display shows the IP Address screen again, it will display a 12-digit IP
address. Enter this address into your web browser as http://###.###.###.###. You
may have to enter the operator password. There is no default password, but if you
have already set one, you will have enter it here.
and download the complete User Guide, which contains
http://192.168.0.1 in your web
7