Installation Instructions; Connection Cable - AEG HK654079XB Notice D'utilisation

28 www.aeg.com
comes on.
comes on.
and a number come
on.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION INSTRUCTIONS

WARNING!
Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into cor-
Problem Possible cause
The Automatic Switch
Off operates.
The Child Safety Device
or the Lock function op-
erates.
There is an error in the
appliance.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
rect built-in units and work surfaces
that align to the standards.

8.2 Connection cable

• The appliance is supplied with the
connection cable.
• Replace the damaged mains cable
with a special cable (type H05BB-F
Tmax 90°C; or higher). Speak to your
local Service Centre.
Remedy
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
ter.