Krüger & Matz KM0536 Mode D'emploi page 10

TROUBLESHOOTING
If you're experiencing difficulties while using this product, read the table
below. Check if the problem was not caused by other equipment (please
check the connection). If you are unable to solve the problem, contact an
authorized service point for check up/repair.
Problem Possible reason
No sound 1. Power was turned off
2. Power plug has been unplugged
3. Volume set to minimum
No power 1. Power was turned off
SPECIFICATION
Power output (RMS)
Frequency response
Phase selection
S/N ratio
Power consumption in standby
Impedance
Crossover
Inputs
Speaker size
Power supply
10
Solution
1. Turn the power on
2. Connect power cord (make
sure it's properly plugged)
3. Adjust the volume level
1. Turn the power on
300 W
35 Hz ~ 2500 Hz
0º / 180º
≥ 78 dB
1 W
4 Ω
50~150 Hz
Line input, 2x high level input
12"
220-240 V; 50/60 Hz
Owner's manual