LEMAN LOPOG226 Manuel D'utilisation page 20

2. Switch status check
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the
power switch is in the ON position, the power tool will start operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated
capacity. The extension cord should be kept as short as practicable.
4. Electrical safety
The electric motor has been designed for one voltage only. Always check that the power supply corresponds to
the voltage on the rating plate.
This machine is double insulated in accordance with EN 60745
5. Work surface
Take care to avoid pointed projections and nails, etc. This will wipe out the sandpaper and probably damage
the sponge pad as well.
1. Switching On and Off (Fig 11)
To switch on:
- Hold the main handle (4) with one hand and the front handle (2) or the back handle (5) with the other hand.
- To start the machine, press the On/Off switch (20) and keep it pressed.
- To switch off the machine, release the On/Off switch (20).
- To work continuously, press the On/Off switch (20), then press the lock-on button (21). To switch off the machine,
press the On/Off switch (20) and then release it.
CAUTION: After the machine has been switched off, the sanding disc will still rotate for a time. Take care that parts
of your body do not come into contact with the disc and do not set the machine down while it is still rotating!
2. Selecting the speed (Fig 11)
This machine is equipped with a built-in electronic control circuit that can adjust and regulate the number of
rotations. Generally, you should use the higher speed for fast stock removal and the lower speed for more precise
control.
- Adjust the speed with the adjuster knob (22), depending upon the contents of operation: this can be done even
while the machine is running.
- The speed can be adjusted from the lowest speed 800rpm to full speed 1700rpm.
NOTE:
- If the tool is operated at low speeds for a long period of time, run the machine at the fastest speed for few ten
seconds when the work is finished in order to cool down the motor.
- If the tool is operated continuously at low speeds for a long period of time, the operation life of the motor will be
reduced.
- The speed adjusting dial can be turned only as far as full speed Max and lowest speed Min. Do not force to pass
full speed or lowest speed, or the speed adjusting function may no longer work.
3. LED light (Fig 12)
When working, LED light can be switch on to lighten the dark site and to check the sanding surface smooth or not.
- To switch on, press the rocker switch (23) in position "I" (ON).
- To switch off, press the rocker switch (23) in position "O" (OFF).
NOTE:
The LED will only light up when the machine is started. Do not forget to switch off the lightbafter using.
4. Operation
- Effective control of this machine requires two-handed operation for maximum safety and control. Do not control
the machine's head: hold the machine with both hands by using the two handles.
- It is vitally important to keep stable footing at all times, especially when standing on scaffolding or stilts.
- Before switching on the machine, keep the sanding head slightly away from the work surface.
- Once the machine and vacuum cleaner are set up and all safety measures and equipment are in place, begin by
turning on the vacuum cleaner and then the machine.
- Bring carefully the sanding head in contact with the work surface, as lightly as possible: just enough to keep the
sanding head flat against the surface.
GB
; therefore no earth wire is required.
OPERATION
20