VINCENT DAC-1 MK Manuel D'utilisation page 32

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STANDBY CONTROL (POWER CONTROL)
Caution:
Many devices which can be controlled by a switching signal (not preamplifiers or integrated ampli-
fiers), have two terminals which do not differentiate between input and output. In this case either of
the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected! All
receiving devices must not be connected to more than one preamplifier or integrated amplifier (directly
or indirectly)!
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and frequency
can be read on the back of the device beside the socket for the mains. If the electricity supply is appropriate,
push the inlet connector of the supplied mains cable firmly into socket for the mains on the back of the device.
Connect the other end of the mains cable to a mains socket.
Vincent
32
CONNECTIONS FOR THE

Publicité

Table des Matières
loading

Produits Connexes pour VINCENT DAC-1 MK

Table des Matières