VINCENT DAC-1 MK Manuel D'utilisation page 30

The DAC-1 MK has two analogue signal outputs on the back of the device. The signal can be input to a
traditional analogue audio component (amplifier) via the analogue outputs (6).
Use of one of the analogue outputs with RCA connectors
This is where the stereo audio signal converted to analogue by the high quality D/A converter and amplified
by the output stage. An RCA cable is required for connection to an amplifier. Connect one pair of RCA con-
nectors ("L" and "R") in the field "ANALOG OUTPUTS" (6 with the left and right audio connectors of the ampli-
fier input (standard line level input) which is usually labelled "CD," "LINE IN" or "FRONT R/L". If you want,
you can use both outputs at the same time.
DAC-1 MK
Use of the analogue output with XLR connectors
This is where the stereo audio signal converted to analogue by the high quality D/A converter and ampli-
fied by the output stage. Two XLR cables are required for connection to an amplifier. Connect the XLR con-
nectors "L" and "R" in the field "ANALOG OUTPUTS" (6) with the left and right connectors of the XLR
amplifier input which is usually labelled "CD," "XLR IN," "BALANCED IN" or "FRONT R/L".
DAC-1 MK
Vincent
30
CONNECTION TO AMPLIFIER,
RECEIVER OR PREAMPLIFIER
RCA connection
RCA connection
LINE IN
XLR connection
CD
BALANCED IN
preamplifier, integrated
amplifier, receiver
CD
preamplifier, integrated
amplifier, receiver