Master CCX 4.0 Manuel D'utilisation Et De Maintenance page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
pedestrians. The connection of
improper
electrical
improper installation, will cause
the electrical shock hazard.
►1.22. Conditions of use:
A) Air temperature: 18°C to 45°C;
Water temperature: <45°C.
B) The air supply must be free
of dust, pollutants, or additional
cleaning should be used.
►►2. UNPACKING
►2.1. Remove all packaging materials
used to wrap and deliver the appliance
and dispose of them in compliance
with the Standards in force.
►2.2. Extract all items from the
packaging.
►2.3. Verify if damage undergone
during transport. If the appliance
appears damaged, inform the dealer,
where the purchase was made,
immediately.
►►3. ASSEMBLY
The device is equipped with wheels to
facilitate handling. Depending on the
model, wheels can be found already
installed or not. Components equipped
with relative nuts and bolts are found
inside the packaging (Fig. 1).
►►4. OPERATION
WARNING: Thoroughly read the
"INFORMATION
SAFETY", before switching the
appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
Figures and texts of this book are protected by COPYRIGHT.
voltage
or
REGARDING
WARNING: Verify if your electronic
system
is
earthed
Connection to the mains must
be made in compliance with the
National Standards in force. Power
the appliance only with voltage and
frequency as specified on the data
plate.
NOTE:
These
connected to the water mains, by
connecting the pipe to the fitting
(Fig. 13).
►►4.1. SWITCHING ON:
►4.1.1. Open the tank door (Fig. 2).
►4.1.2. Fill the tank with water (Fig. 3);
water level must be within MIN and
MAX level of the graduated scale
(Fig. 4), in order to prevent risks.
►4.1.3. Close the tank door (Fig. 5).
►4.1.4. Connect the power plug to the
mains (Fig. 6).
►4.1.5. Press the ON/OFF button to
switch on the appliance (Fig. 9).
►►4.2. CONTROL PANEL, USE
AND FUNCTIONS (Fig. 7-8):
►ON/OFF: Allows turning on or off the
cooler.
►SPEED: Increases or decreases the
ventilation speed of the device. You
can choose from three speeds: LOW,
MID and HIGH.
►COOL: Enables or disables the
cooling mode.
►SWING: Enables or disables the
automatic swing of the fins to direct
the air flow.
► ANION : Enables or disables the
ionisation mode, that is, the release
of negative ions in the atmosphere, to
make air healthier.
►TIMER: Enables or disables the timer
for automatically turning the cooler on
or off (from 1 to 9 hours).
correctly.
models
can
be
en

Publicité

Table des Matières
loading

Table des Matières