Technical Specifications - bca TRACKER4 Manuel D'utilisation

Technical Specifications

• Frequency: 457 kHz
• Batteries: Three AAA/LR03 alkaline batteries. Do not use rechargeable,
lithium, Oxyride, PowerPix or any other non-alkaline battery.
• Battery life: minimum 1 hour in search mode after 200 hours in transmit mode
(approximately 250 hours in transmit only or 50 hours in search only)
• Search strip width: 50 meters
• Tracker4 weight: 6.3 ounces (179 grams) without strap and batteries
• Tracker4 size: 4.7" x 3.0" x 1.0" (12 cm x 7.5 cm x 2.6 cm)
• Tracker3+ weight: 7.6 ounces (215 grams) without strap and batteries
• Tracker3+ size: 4.6" x 2.8" x 0.9" (11.6 cm x 7.1 cm x 2.3 cm)
• Tracker S weight: 7.2 ounces (205 grams) without strap and batteries
• Tracker S size: 4.5" x 2.8" x 1.0" (11.5 cm x 7.1 cm x 2.6 cm)
• Minimum temperature range (at 66.7 percent battery power):
transmit mode: -20°C to +40°C (-4°F to 104°F);
search mode: -20°C to +40°C (-4°F to 104°F)
• U.S. Patent number 6,167,249 & 6,484,021 B1
Model No.: Tracker4
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this device.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device."
Model No.: Tracker3+ Model No.: Tracker S
91