Safety Regulations; Proper Use; Technical Data - EINHELL DMH 250/2 Mode D'emploi D'origine

Anleitung_DMH_250_2_11050_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the chisel hammer to any use other than
that intended.
Be careful with combustible materials. Sparks may
be caused by impact.
Keep pneumatic tools safe from children.
Always concentrate while you work. Do not work if
you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set the
working pressure.
Never use oxygen or combustible gases as an
energy source.
Never allow the tool to run unloaded at full idle
speed.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Wear the necessary protective clothing, particularly
goggles, ear-muffs and safety gloves, when
working with the chisel hammer.
8
01.09.2010 10:56 Uhr
2. Layout (Fig. 1)
1 trigger lever
2 air regulating screw
3 cylinder
4 clamping spring
5 plug-in nipple for air supply

3. Proper use

The chisel hammer is a pneumatic tool for general
use. It can be used, for example, to cut grooves, to
remove tiles or plaster, to knock holes through walls,
to cut metal sheet and plate, and to knock off bolts
and rivets.
The exhaust air leaves the housing to the front.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Repairs and maintenance work are to be carried out
only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.

4. Technical data

Permissible working pressure max.:
Air consumption: 115 l/min
Chisel holder (hexagonal): 9.8 mm
Stroke:
Blow rate: 4500 blows/min
Recommended hose diameter: Ø 10 mm
Weight:
Seite 8
6,3 bar
43 mm
1.1 kg