VelLight LEDC10 Mode D'emploi page 5

LEDC10
Step 5 – Reconnect the connector cable
 Make sure the connector is fully opened.
 Insert the cable and close the connector.
You can now close the touch panel.
5. Wiring
Wiring: RGB mode
For RGB mode, wire the controller as follows:
Wiring: colour temperature mode
For colour temperature mode, wire the controller as follows:
Wiring: Dimmer mode
For dimmer mode, wire the controller as follows:
V. 01 – 28/03/2013 5 ©Velleman nv