Publicité
Les langues disponibles
Les langues disponibles
(3) As you hold the band to make sure the handle bolt
won't come loose, insert the handle bolt into the mount.
(Fig. 5)
(4) Adjusting the band to a position that is suitable for the
task, turn the side handle to fasten the band. Make sure
that the band is securely fastened. (Fig. 6)
7.
How to install tool
CAUTION
For tools such as a bull point, use only metabo HPT
genuine parts.
(1) Clean, then smear the tool shank with the grease or
machine oil.
(2) To attach the tool (SDS max shank), insert it into the
hole until it contacts the innermost end of the hole as
illustrated in Fig. 7.
If you continue to turn the tool with slight pressure, you
can feel a spot where there is a hitch. At that spot, pull
the grip to the direction of an arrow mark and insert the
tool all the way until it hits the innermost end.
Releasing the grip reverts the grip and secures the tool
in place.
Band
Mount
Handle bolt
Fig. 5
Side handle
Fig. 6
Tool
Tool shank
(3) Pull the tool to make sure it is locked completely.
(4) To remove the tool, fully pull the grip in the direction of
the arrow and pull out the tool.
8.
Deciding Working Position of Tool
The tool can be turned every 30 degrees and can be
fi xed at the position of 12 steps.
(1) As shown in Fig. 8, the blade angle can be freely
changed if the grip (B) is turned in the direction of Ⓑ
in a state where grip (B) is slid in the direction of Ⓐ.
(2) Release grip (B) and turn the tool, and make sure that
it is locked completely.
9.
Removing Tool
As shown in Fig. 7, pull grip, and pull out the tool.
CAUTION
Be sure to grip the handle and side handle or
cylinder case cover during work. Do not hold by
the grip during work. If you pull it by mistake, the
bull point could jump out.
English
Grip
Fig. 7
Grip (B)
Fig. 8
7
Publicité
