Metabo HPT H 60MEY Instructions De Sécurité Et Mode D'emploi page 8

English
(2) Turn the grip or the tool as illustrated in Fig. 4 and fi x
the tool to the desired working direction.
Grip
(3) Switch the selector lever to "hammering " and turn
the tool, and make sure that it is locked completely.
8. Removing Tool
As shown in Fig. 5, slide the grip in the direction of Ⓐ
and pull out the tool.
Grip
Tool
shank
Front cap
CAUTION:
Be sure to grip the handle and side handle during
work. Do not hold by the grip during work. If you
pull it by mistake, the bull point could jump out.
8
Mark
Selector lever
Fig. 3
Fig. 4
Fig. 5
9. Move the side handle
The side handle can be fi xed at any desired position;
360 degrees, and can also be fi xed at any position in
the back-and-forth direction.
(1) Loosen the handle by turning the grip in the direction
of Ⓐ as shown in Fig. 6.
(2) Adjust it to a position where vertical (up-and-down)
operation can be facilitated as illustrated in Fig. 7, Fig.
8, and Fig. 9.
(3) Turn the grip in the direction of Ⓑ and fi x the handle.
Grip
Ⓑ
Ⓐ
Fig. 6
Fig. 8
10. Power lamp
The power lamp lights up when the power cord is
plugged into an electrical outlet. (Fig. 10)
11. Regulating the number of impact rate hammering
(Fig. 11)
This Demolition Hammer is equipped with a built-in
electronic control circuit that can adjust and regulate
the number of times of hammering. This Demolition
Hammer can be used by adjusting the impact rate
selector switch, depending upon the contents of
operation, such as chiseling fragile materials, chipping,
centering, etc.
Fig. 7
Fig. 9
Power lamp
Fig. 10