Fix The Ceiling Hanger Bracket - Fanelite 52YFT-1075 DOMINICA Mode D'emploi

7. FIX THE CEILING HANGER BRACKET

WARNING : The fixing must be done securely in the structure of the ceiling by a qualified person.
Depending on the structure of your ceiling, use suitable screws and washers. Do not fix the ceiling
support in a structure thinner than 50 mm or in hollow elements, in order to avoid any risk of falling.
Make sure that the fixing is very solid and can support at least 68 kg by pulling it. We decline all re-
sponsibility in the event of a fall of the ceiling fan.
You can install the hanger bracket on an inclined ceiling of 25° maximum. As below, if your ceiling is inclined,
the lugs of the hanger bracket must be on the highest side of your ceiling. Do not put it on the lowest side of
your ceiling.
WOOD CEILING
Position the support in the desired location and fix it using the screws and washers provided.
CONCRETE CEILING
Position the support in the desired location and mark the holes to be made. Remove the support and drill the
concrete structure by making 2 Ø 8 mm holes. Remove dust and introduce the anchor studs supplied using
a hammer (leave the threaded rod sticking out). Remove nuts and washers, replace the support and replace
the washers and nuts. Tighten the nuts securely using a suitable wrench.
24
WOOD CEILING-STRAIGHT
Hanger bracket against the ceil-
ing, lugs on any side
Wood
Hanger
bracket
CONCRETE CEILING-STRAIGHT
Hanger bracket against the ceil-
ing, lugs on any side
Concrete
Hanger
bracket
WOOD CEILING-INCLINED
Hanger bracket against the ceil-
ing, lugs on highest side
Wood
Hanger
bracket
CONCRETE CEILING-INCLINED
Hanger bracket against the ceil-
ing, lugs on highest side
Concrete
Hanger
bracket