Maintenace; Lubrication; Change The Timing Belt - LEMAN PON250 Manuel D'utilisation

MAINTENCE
Warning:
For your safety, remove the plug from power source
outlet before adjusting, maintaining, of lubricating your
belt and disc sander.
Warning:
To avoid electrocution or fire, any repairs to electrical
systems should be done only by qualified service
technicians. Unit must be reassembled exactly to
factory specifications.
If power cord is worn or cut., or damaged in any way, have it
repaired immediately.
Frequently blow out or vacuum out any dust that may
accumulate inside the motor. A coat of automobile-type wax
applied to the worktable will make it easier to feed the work
while finishing.
Do not apply wax to the abrasive belt table because the belt
could pick up the wax and deposit it on the pulleys, cause the
belt to slip.

LUBRICATION

The BALL BEARINGS in this machine are packed with
grease at the factory. They require no further lubrication.

CHANGE THE TIMING BELT

1. Using a Phillips screwdriver remove 3-pan head screw
located in the cover.
2. Remove the cover.
17
EN