LEMAN PON250 Manuel D'utilisation page 61

SURFACE SANDING ON THE SANDING BELT
Warning:
To avoid injury from slips, jams or thrown piece, adjust
the backstop to clear the sanding surface by no more
than 2mm When checking clearance between the belt
and work support, press the belt flat against the metal
beneath it.
Hold the workpiece firmly with both hands, keeping fingers
away from the sanding belt.
Keep the end butted against the backstop and move the work
evenly across the sanding belt.
sanding very thin pieces.
For sanding long pieces, remove the work support.
Apply only enough pressure to allow the sanding belt to
remove material.
END SANDING ON THE SANDING BELT
It is more convenient to sand the ends of long workpiece with
sanding belt in vertical position.
If it is necessary, install the worktable assembly.
Move the work evenly across the sanding belt.
accuracy, use a mitre gauge (must installing the work table).
SANDING CURVED EDGES
Always sand inside curves on the idler drum as shown.
Warning:
Never attempt to sand the ends of a workpiece on the
idler drum, applying the end of the workpiece to the idler
drum could cause the workpiece to fly up and result in an
injury.
Use extra caution when
For
15
EN