Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FAN STRUCTURE
INSTALLATION
1.
Place the housing of the motor (11) onto the pedestal (12).
2.
Tighten the fixing screw of the motor housing (14) against its designated location (15).
3.
At the other side, tighten the adjustable tilt button (13) into the pedestal.
4.
Place the carry bolt (17) in the hole under the adjustable tilt button (13).
5.
Fix the carry button for the motor housing (16) onto the carry bolt (17).
6.
Place the protective rear cover (6) with the handle (7) upwards over the motor shaft (8) and then tighten it to
the motor housing using the 4 screws (5).
7.
Slide the fan blades (3) over the motor shaft (8) and fix them to the motor shaft using the fixing screw (4).
8.
Turn the clips of the protective front cover (1) outwards and hang the protective cover over the edge of the
protective rear cover. Make sure that the opening at the bottom of the protective front cover (2) is aligned
with the opening at the bottom of the protective rear cover.
9.
Insert the screw (2) through both openings at the bottom of the protective covers and fix the covers together
using the nut.
10.
Finally, close the clips around both protective covers.
OPERATION INSTRUCTIONS
1.
Place the fan on a flat surface.
2.
Check whether the voltage corresponds to what is indicated on the product label.
3.
Insert the plug into a wall outlet.
4.
Rotate the button (9) to activate the fan and set the airflow speeds.
Position I provides the lowest airflow.
Position II provides an average airflow.
Position III provides a high airflow.
5.
Rotate the button to the '0' setting to switch off the fan.
6.
The fan oscillates automatically from left to right. If you'd like to fix its position, depress the oscillation button
(10) at the rear of the fan. The fan will then remain in that position. Pull the button (10) back up to make the
fan oscillate automatically again.
7.
You may tilt the fan head by loosening the tilt knob (13) and tightening it again in the desired tilt position.
8.
Remove the plug from the wall outlet when not using the fan. Make sure that the fan is fully switched off
before doing so.
1. Protective front cover
2. Protective covers fixing screw location
3. Fan blades
4. Fan blade fixing screw
5. Protective rear cover fixing screws
6. Protective rear cover
7. Carry handle
8. Motor shaft
9. Speed setting dial
10. Oscillation button
11. Motor housing
12. Pedestal
13. Adjustable tilt button
14. Motor housing fixing screw
15. Location for motor housing fixing screw
16. Motor housing carry button
17. Carry bolt
7
Publicité
Table des Matières
