Publicité
Les langues disponibles
Les langues disponibles
GOMERA
HANGING THE FAN TO BRACKET
INSTALLING BLADE
hofflights.com
INSTALLATION MANUAL
Lift the fan up to the hanger bracket, steer the ball in from the side of the
bracket and lower it into the recess of the bracket. Rotate the ball around until
the groove in the side of the ball aligns with the protrusion on the upper edge of
the recess. When aligned the fan should drop slightly as it assumes it's correct
position. This is to prevent rotation of the rod and fan when the unit is working
After set up the code switch, put the receiver through the hanging bracket for
wiring connecting
Connect the push connector of fan to remote control receiver, please be noted,
the wire position need to be "brown to brown, blue to blue, org to org, green/
yellow to green/yellow". The push connector could not be pushed in and will
cause fan damage if the wire position iswrong.
Connect the push connector of hanging bracket to.
A.C. Input power of remote control.
"Brownto brown; blue to blue, green/yellow to green/yellow"
IMH-105 v.01
1
Insert the fan blade into the motor
housing and pay attention to the
blade marking facing up.
2
Align holes and fasten the blade to
the motors with provided screws.
Repeat procedure for remaining
blades
15
Publicité
