Installing Equipment; Before You Begin - D-Link DFL-1600 Guide D'installation

Interface Interface
Port Name Type IP Address
1 WAN1 DHCP Client 0.0.0.0/0
2 WAN2 Static IP 192.168.120.254/24 Disabled
3 WAN3 Static IP 192.168.130.254/24 Disabled
4 WAN4 Static IP 192.168.140.254/24 Disabled
5 DMZ Static IP 172.17.100.254/24
6 LAN1 Static IP 192.168.1.1/24
7 LAN2 Static IP 192.168.2.1/24
8 LAN3 Static IP 192.168.3.1/24
Table 5. DFL-2500 Default Interface Assignment
Note: For security, D-Link NetDefend Firewalls
only allow Web GUI access from the LAN1
port by default. Therefore, for the DFL-1600,
Web GUI access is only permitted on port No.
4. For the DFL-2500, Web GUI access is only
permitted on port No. 6.
Installing and Connection
This chapter describes how to install a
DFL-1600/DFL-2500 device in a standard
19-inch equipment rack and how to connect
network and power cables to the device.

Before You Begin

Observe the following precautions to help
prevent faults, equipment failures and injuries:
- Before installation, always disconnect the
power supply.
- Ensure that the room in which you operate
the device has adequate air circulation and
that the room temperature does not exceed
40˚C (104˚F).
- Allow 1 meter (3 feet) of clear space from the
front and back of the device.
- Do not place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and vented sides.
- Correct any of the following hazardous
conditions before any installation: moist or
wet floors, leaks, ungrounded/frayed power
cables, or missing safety grounds.
4  D-Link NetDefend Firewall

Installing Equipment

Web-Based
Mgmt
You can mount the DFL-1600/DFL-2500 device
Disabled
into a standard 19-inch equipment rack. To
install an DFL-1600/DFL-2500 device into a
rack:
Disabled
Enabled
1. Attach the mounting brackets to each side
Disabled
of the chassis as shown in figure 5 and
Disabled
secure them with the provided screws.
Figure 5. Attaching Rack Mount Brackets
2. Use the screws provided with the equipment
rack to mount the device in the rack.
Figure 6. Installation Using a Standard-sized
Connecting Power and Turning On/Off
The AC Power cord shipped with the device
connects the device to earth ground when
plugged an AC grounding-type power outlet.
The device must be connected to earth ground
during normal operation.
To connect power to the device, plug one
end of the AC power core into the AC power
appliance inlet on the back panel of the device.
Plug the other end into an AC power source.
Note: D-Link recommends the use of a surge
protector with your power connection.
Equipment Rack