About This Guide; Unpacking The Product; Product Overview - D-Link DFL-1600 Guide D'installation

About This Guide

This guide contains step-by-step instructions
for setting up the D-Link DFL-1600/DFL-2500
Firewall. Please note that the model you have
purchased may appear slightly different from
those shown in the illustrations.

Unpacking the Product

Open the shipping carton and carefully unpack
its contents. Please consult the packing list
located in following information to make sure all
items are present and undamaged. If any item
is missing or damaged, please contact your
local D-Link reseller for a replacement.
- One (1) DFL-1600 or DFL-2500 NetDefend
Firewall Appliance.
- One (1) Power Cord
- One (1) Console Cable (RS-232 Cable)
- One (1) Ethernet (CAT5 UTP/Straight
Through) Cable
- One (1) Ethernet (CAT5 UTP/ Cross Over)
Cable
- One (1) Master CD (CD-ROM containing
product documentation in PDF format)
- Two (2) Rack Mounting Brackets

Product Overview

Front Panel - DFL-1600/DFL-2500
A B C D
Figure 1. DFL-1600/DFL-2500 Front Panel
Item Feature Description
A LCD Panel Used to display status and operation
messages.
B Power LED Indicates that the NetDefend UTM
firewall is powered on.
C System LED Indicates the system status of the
NetDefend UTM firewall
D Keypad These keys are used in conjunction with
the messages on the LCD Panel.
E 10/100/1000Mbps For the DFL-1600, the assigned port
Ethernet Ports* numbers are 1 to 6 (from left to right).
For the DFL-2500, the assigned port
numbers are 1 to 8 (from left to right).
F Console Port Used to access the NetDefendOS
Command Line Interface (CLI) via
RS-232 Cable.
Table 1. DFL-1600/DFL-2500 Front Panel Descriptions
2  D-Link NetDefend Firewall
* Configurable Gigabit Ethernet ports with autosensing
duplex and auto MDI/MDIX. When configuring a
particular port, reference the interface name that
corresponds to the location of the port. For the default
interface bindings of each Ethernet port, see tables 4 and
5 on pages 3 and 4.
Device Status LEDs and Ethernet Port LEDs
The device LEDs show information about current
device status. When the device is powered
up, the POWER LED changes from off to solid
green and the SYSTEM LED changes from off
to solid green. Startup takes approximately one
minute to complete. The Ethernet LEDs show
the status of each Ethernet port. Table 2 lists
the name, color, status, and description of each
device LED.
Note: If you would like to turn the device off and
on again, we recommend waiting a few seconds
between shutting it down and powering it back on.
Name
Power
System
E F
TX/RX Status
LINK Speed
Table 2. Device Status LED Descriptions
Link TX/RX
Speed Status
Figure 2. Ethernet
RJ-45 Port LEDs
Color Status - Description
Green Light Off - Device is
powered off.
Solid Green - Device is
powered on.
Green Light Off - Device is
powered off or is starting up.
Solid Green - System is
normal operation.
Light Off - No Link.
Green
Solid Green - Link present.
Blinking Green - Port is
sending or receiving data.
Green/ Light Off - Port is operating
Orange at 10Mbps.
Solid Green - Port is
operating at 100Mbps.
Solid Orange - Port is
operating at 1000Mbps.