GE AEM10 Manuel D'utilisation Et Instructions D'installation page 4

About the controls on the air conditioner
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
The display always shows the
room temperature except when
setting the Set temperature or
the Delay timer.
Air Conditioner Controls
Controls
Power Pad
Turns air conditioner on and off. When
turned on, the display will show the room
temperature.
Display
Shows the room temperature or time
remaining on the Delay timer. Shows the Set
temperature while setting the temperature in
Cool or Energy Saver modes. The Set light will
turn on while setting.
NOTE: The display will change to show the
room temperature after settings have been
made. To recall the Set temperature, press the
Temp Increase ▲ or Decrease ▼ pads.
Temp Increase
Use to set temperature when in Cool or Energy
Saver mode. The Set light will turn on while
setting.
Delay Timer Increase ▲ (+) /Decrease ▼ (–)
Pads
Each touch of the Increase ▲ / Decrease ▼
pads on the unit or the Increase
pads on the remote control will set the delay
time when using the Delay 1–24hr timer (
The Set light will turn on while setting.
Fan Speed Pads
Use to set the fan speed to Low, Med, High
or Auto on the unit . NOTE: On the remote
control, use the fan speed Increase
Decrease
Med or High . Use the Auto pad to turn Auto
fan on.
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
4
used after the power is restored. If the Delay 1–24hr
Light indicates the unit
is in the temperature or
delay time Set mode.
Light indicates the delay timer is set.
▲ ▼
/Decrease Pads
+
/ Decrease
+
–
pads to set the fan speeds to Low ,
Delay 1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
Remote Control
Mode Pad
Use to set the air conditioner to Cool , Energy
Saver or Fan Only mode.
Delay Pads
Delay ON— When the air conditioner is off, it
can be set to automatically come on in 1 to 24
hours at its previous mode and fan settings.
Delay OFF— When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or
the pad on the remote control. Each touch
of the Increase ▲ / Decrease ▼ pads on the
unit or the Increase
the remote control will set the timer in
1-hour intervals. The Set light will turn on
while setting.
To review the remaining time on the Delay
1–24hr timer, press the Delay 1–24hr pad on the
unit or the
the Increase ▲ / Decrease ▼ pads on the unit
–
or the Increase
).
remote control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad
until the light on the Delay 1–24hr pad goes off.
/
feature was set, it will resume countdown. You may
need to set a new time if desired.
Delay
Delay timer Increase
Auto Fan on/off
Fan speed Increase
Temp
Power Unit power on/off
+ –
/ Decrease
pads on
pad on the remote control. Use
+ –
/ Decrease
pads on the