Publicité
Les langues disponibles
Les langues disponibles
Connecting Wires to Terminals
Ignition key
switch
Car fuse box
(Main fuse)
+
–
Battery
Connect to the vehicle's parking brake detection
switch harness.
Connect to vehicle's reverse lamp harness when
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
Connect to the terminal that is grounded when either
To connect the Kenwood navigation system,
consult your navigation manual.
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
4
|
KVT-512/KVT-532DVD
ACC
Ignition wire (Red)
Battery wire (Yellow)
Car fuse box
Ground wire (Black)- (To car chassis)
For the sake of safety, be sure to connect the parking sensor.
PRK SW
using the optional rear view camera.
To car light control switch
To steering remote
the telephone rings or during conversation.
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
If no connections are made, do not let the cable come out from the tab.
USB device
(commercially available)
If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit, that
in turn may start a fire. Always connect those
wires to the power source running through
the fuse box.
FUSE ( 15A )
Parking sensor wire (Light Green)
Reverse sensor wire (Purple/White)
Dimmer control wire (Orange/White)
Steering remote control input (Light Blue/Yellow)
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
USB connector
Publicité
