Domo DO8140 Mode D'emploi page 32

DO8140
perfectly behind the fan blades (Fig. 2). Use the spinner to fasten the fan blades onto
the motor drive.
Position the front grill on the rear grill and fasten them together with the help of the
attaching clip. Finally, use the screw at the top of the rear grill to fasten both halves of
the grill together firmly. (Fig. 3)
2
3
7
4
2
3
INSTRUCTIONS
Speed regulation with the help of the 4 buttons on the control panel.
0: off
1: low speed
2: medium speed
3: high speed
To allow the fan to oscillate, push in the oscillation button. To stop the fan from
oscillating, pull the button up.
To direct the ventilation up or down, push down or pull up gently on the grill to adjust
the direction up or down.
The height of the fan can be adjusted by loosening the clamp and lengthening or
shortening the telescopic tube. Then tighten the clamp firmly before turning the fan on.
MAINTENANCE
This fan requires very little maintenance. Never try to repair the fan yourself. If it is
defective, have it checked and/or repaired by a qualified person.
Prior to assembling the fan or cleaning it, remove the plug from the outlet.
Keep the rear grill free of dust and other substances in order to allow free circulation
of the air around the motor. Do not disassemble the fan to remove dust from the motor.
You may clean the exterior of the machine with a soft moist cloth and a mild
detergent. Carefully dry the machine afterwards.
Never use corrosive or abrasive products to clean the machine.
Make sure that no water gets into the motor of the machine.
32