Domo DO8140 Mode D'emploi page 31

Les langues disponibles

www.domo-elektro.be

PARTS

1. Front grill

2. Spinner

3. Fan blades

4. Plastic screw

5. Rear grill

6. Screw for fastening rear grill

7. Motor drive

8. Oscillation button

9. Motor

10. Control Panel

11. Small screw

12. Clamp

13. Telescopic tube

14. Base mount

15. Base

16. Attaching clip

FASTENING THE BASE AND THE MOTOR

Loosen the butterfly screw and pinion at the bottom of the telescopic tube. Position the

telescopic tube in the base mount and fasten the tube with the pinion and the butterfly

screw. (Fig. 1)

Position the four parts of the base in the base mount. Make sure that the parts are

inserted properly. (Fig. 2)

Loosen the clamp and extend the top part of the tube completely and block the tube at

this height by tightening the clamp again (Fig. 3 - 4)

Make sure that the clamp is tightened before mounting the motor. Loosen the small

screw at the back of the control panel. Place the motor on the telescopic tube. Tighten

the small screw again, making sure that the screw is aligned with the recess in the

telescopic tube. The small screw must be fully tightened prior to using the fan. (Fig. 5)

FASTENING THE GRILL AND THE FAN BLADES

Remove the spinner from the motor drive (or remove it from the packaging). Loosen

the plastic screw from the motor drive. Position the grill behind the motor drive and

use the plastic screw to fasten the grill. (Fig. 1)

Place the fan blades on the motor drive. Make sure the pin on the motor drive fits

DO8140