GE AEN08 Série Manuel D'utilisation Et Instructions D'installation page 12

INSTALL THE AIR CONDITIONER
10
IN THE CASE
Slide the air conditioner into the case by
A
the base pan. Do not push on the controls,
styrofoam air discharge housing or the finned
coils. Make sure the air conditioner is firmly
seated.
Base Pan
Replace the 2 ground screws removed earlier,
B
one on each side of the case.
IMPORTANT: The ground screws must be
reinstalled to ensure a proper ground.
Reinstall the control to the panel housing
C
be replacing the three screws you removed
earlier.
Installation Instructions
Do not press on
damage to the unit
may result
install screws
12
INSTALL THE AIR CONDITIONER
10
IN THE CASE (CONT.)
Attach the front grille to the case by inserting
D
the tabs on the grille into the slots on the front
top of the case. Push the grille in.
Secure the front grille to the case by replacing
E
the 2 screws removed earlier. Press on the top
of the grille to help with side screw installation.
Connect power.
F