AQUALUX 104274 Notice D'installation Et D'utilisation page 19

The chemical parameters of the water are maintained in the following ranges:
Acidity
Shock chlorine
Bromine
PHMB
Total alkali strength °F
DIGITAL CONTROL PANEL SETTINGS
Settings
- Required temperature
- Clock
TIME ON indicator
TIME ON setting
PICTOGRAMS
CLOCK
COOLING
PERMANENT DISPLAY
- The display shows the time when the machine is turned off.
- The display shows the temperature of the water in the pool when the machine is turned on.
HOT/COLD MODE
- Press the MODE button several times to switch from one mode to another.
ADJUSTING THE WATER TEMPERATURE
- Press and to adjust the temperature.
The temperature flashes.
- After five seconds, the display stops flashing.
ADJUSTING THE TIME
- Press to adjust the operating times.
- The time flashes. Press the time button
- Press and to change the settings.
- Before the display stops flashing, press
- Press and to change the settings.
- Press and the temperature of the water appears.
- After 30 seconds, the display stops flashing.
AUTOMATIC MODE
NOTPACAQX - ind Q – 0413
pH 7.00 – 7.80
ppm max 15 for 24 hours
ppm 2 – 3
ppm 20 – 50
8 – 12
TIME OFF setting
indicator
HEATING
(can be changed when the machine is on or off)
Free chlorine ppm
Salinity
Ozone ppm 0.8 – 1.0
Hardness °F
TIME OFF setting
AUTOMATIC
(can be changed when the machine is on or off)
again to change the times.
to set the minutes.
18/41
1 – 3
g/l 0 – 5
10 – 50
Hot or Cold mode*
On / Off
Time setting
AUTOMATIC STOP