Makita DMP 180 Manuel D'instruction page 8

OPERATION
NOTE: The standard adapters vary depending on the
country.
Using the Schrader valve adapter
1. Unfold the air chuck clamp.
2.
Attach the air chuck to the valve stem.
► 1. Air chuck clamp 2. Valve stem 3. Air chuck
3.
Fold the air chuck clamp firmly.
4. Turn on the tool, and then set the pressure value
appropriate for the tire using the pressure gauge.
5. Keep pulling the switch trigger until the tool stops.
The tire is inflated with the specified pressure.
Using the Presta valve adapter
1. Loosen the locking nut on the valve stem.
1
► 1. Locking nut
2. Unfold the air chuck clamp.
1
2
3
8 ENGLISH
3. Attach the Presta valve adapter to the valve
stem, and then attach the air chuck to the Presta valve
adapter.
1 2
► 1. Presta valve adapter 2. Air chuck 3. Air chuck
clamp 4. Valve stem
4. Fold the air chuck clamp firmly.
5.
Turn on the tool, and then set the pressure value
appropriate for the tire using the pressure gauge.
6. Keep pulling the switch trigger until the tool stops.
The tire is inflated with the specified pressure.
7. Remove the air chuck and Presta valve adapter,
and then tighten the locking nut.
Using the sport ball needle or
tapered adapter
You can inflate small items such as sport balls or float-
ing tubes. To inflate sport balls, use the sport ball nee-
dle. To inflate floating tubes, use the tapered adapter.
1. Unfold the air chuck clamp.
2. Attach the sport ball needle or tapered adapter to
the air chuck.
1 2
► 1. Air chuck clamp 2. Air chuck 3. Sport ball needle
4. Tapered adapter
3. Fold the air chuck clamp firmly.
4. Insert the sport ball needle or tapered adapter into
the hole on the item.
4
3
4
3