Attaching/Removing The Pram Body At/From Chassis - KIDDY Evoglide 1 Guide D'utilisation

EN
WARNING
Inspect the carrying belts and the bottom regu-
larly for signs or damage and wear.
WARNING
Be aware of the risk of open fire and other source
of strong heat, such as electric bar fires, gas fires,
etc., in the near vicinity of carrycot.
Place both carrying belts on top of each other (fig. 34; no. 1) into the belt pad and
close both snap fasteners (fig. 34; no. 2).
WARNING
Never use the sun roof front frame for carrying
the carrycot (fig. 35)!
Ensure that the head of the child in the carry cot
should never be lower than the body of the child.
5.3 Attaching / removing the pram body at/from chassis
WARNING
Ensure that the parking brake is activated after
unfolding the chassis as described in point 3.1.
If infant carrier adapters were used, they must be removed from the chassis.
The pram body can be used front or rear facing the driving direction.
Insert both plugs of the pram body on the left and right support on the chassis
until they lock into the place and sit tight (fig. 36; no. 1) and the indication at
locking button is "green" (fig. 36; no. 2) .
50 50