Removing/Re-Installing The 5-Point Belt System - KIDDY Evoglide 1 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 79
EN
WARNING
Test by pulling on the belts whether the buckle
is correctly locked.
Finally, the belt system must be tightened. For this purpose pull the central belt
(fig. 20) until the belts touch the child's body.
WARNING
The belt system is adjusted correctly when the
belts lay firmly on the childs body.

4.7 Removing/re-installing the 5-point belt system

Open the Velcro behind the back rest and on the lower side of the seat part
(fig. 21).
Put one hand under the cover and thread the end clip of buckle belt through the
hole of seat plate (fig. 22). Then thread both end clips of hip belts through the lo-
wer holes of back rest (fig. 23). Open the 5-point-buckle and thread the shoulder
and hip belts together through the upper holes of back rest (fig. 24).
Remove the central adjuster (fig. 25; no. 1) and remove then the belt system
frontwards (fig. 25; no. 2).
To re-install the 5 point belt system, follow the steps for removing the belt system
in reverse order.
WARNING
Before using the pushchair seat make sure that
the 5-Point belt system is correctly re-installed,
the buckles match together and work, the belts
46
46

Publicité

Table des Matières
loading

Table des Matières