Hitachi WH 12DAF Mode D'emploi page 15

Masquer les pouces Voir aussi pour WH 12DAF:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE:
Pay attention to the spring orientation. Install
the spring with larger diameter away from
you. (Fig. 8)
1.2 Using as an auxiliary light
(1) Press the switch to turn off the light.
If forgotten, the light will turn off automatically
after 15 minutes.
(2) The direction of the light can be adjusted within
the range of hook positions 1 - 5. (Fig. 9)
Lighting time
AAAA manganese batteries: approx. 15 hrs.
AAAA alkali batteries: approx. 30 hrs.
CAUTION:
Do not look directly into the light.
Such actions could result in eye injury.
1.3 Replacing the batteries
(1) Loosen the hook screw with a phillips-head
screwdriver (No. 1). (Fig. 10)
Remove the hook cover by pushing in the direction
of the arrow. (Fig. 11)
(2) Remove the old batteries and insert the new
batteries. Align with the hook indications and
position the plus (+) and minus (-) terminals
correctly. (Fig. 12)
(3) Align the indentation in the hook main body with
the protuberance of the hook cover, press the hook
cover in the direction opposite to that of the arrow
shown in Fig. 11 and then tighten the screw.
Use commercially available AAAA batteries
(1.5 V).
NOTE:
Do not tighten the screw excessively. Such action
could strip the screw threads.
CAUTION:
G
Failure to observe the following can result in
battery leakage, rust or malfunction.
Position the plus (+) and minus (-) terminals
correctly.
Replace both batteries at the same time. Do not
mix old and new batteries.
Remove exhausted batteries from the hook
immediately.
Larger
diameter
Fig. 8
4
3
2
1
Fig. 9
Screw
Hook
Fig. 10
Fig. 11
Hook main body
Inden-
tation
AAAA
batteries
Indentation
Fig. 12
English
5
Switch
Hook
Phillips - head
screwdriver
Arrow
Hook cover
Protube-
rance
Protube-
rance
Hook cover
15

Publicité

Table des Matières
loading

Table des Matières