Installation - Qlima GH 959 RF Manuel D'utilisation

Masquer les pouces Voir aussi pour GH 959 RF:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
1. Burner effect regulator
2. Gas Main Valve
3. Gas Hose
4. Gas Pressure regulator
5. Protection baffle
6. Gas Cylinder
In addition
To replace the gas container, make sure that the gas container is closed (fol-
low the user instructions provided with the low-pressure regulator). Let the
gas heater cool down first and make sure that there are no open flames or
other sources of heat in the area in which you are working.
Only change the gas container in a flame free environment.
In addition it is recommended that the gasket seals of the regulator and the
flexible rubber hose be checked to ascertain their condition. If you have any
doubt concerning the condition of the hose or the seals, replace them.
Make sure that you do not damage the connection or any other components;
Never turn the gas container upside down in order to make full use of the
contents. This may release liquid residues left in the container that damage
the heater irreparably;
For disconnection or connection of the low-pressure regulator, always follow
the user instructions provided with the regulator;
The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.
Do not twist the flexible tubing or the hose.

INSTALLATION

Use the gas heater in well-ventilated rooms only. A minimum room size of
82m³ is recommended for living rooms and 50m³ for other rooms, but the
room should never be less than 50m³. For ventilation, a surface between
12.5m² and 25m² is recommended.
The room in which the gas heater is used should have enough air circulation
for normal combustion. Therefore it is recommended that the room must
draw at least 100 cm² from the outside to replace the air;
Always place the heater on a flat and stable surface. Never install or use the
heater in a bathroom or bedroom, in the basement, on the upper floors of a
building or in leisure accommodations;
Never position the gas heater too close to other sources of heat (a distance
of at least 1 metre is required between the gas heater and other heating
sources) or inflammable or explosive materials.
During operation, the gas heater should not face objects that can be
damaged or burned;
Position the heater so that the heat is directed towards the center of the
room and towards an open space. In addition, the front, radiant part must
be at least 2.0 meter away from any inflammable materials, i.e. curtains or
sofas;
Never operate the gas heater when the gas container is outside the compart-
ment.
Only replace gas cylinder in a flame free environment.
Before connecting the gascontainer to the device
4
73

Publicité

Table des Matières
loading

Table des Matières