Baumer OADM 20I6 Série Manuel D'utilisation page 34

Steps / edges:
☺
☺
When measuring right next to steps / edges, it is important that the receiving beam is not covered by the
steps / edges. This also applies to depth measurements of holes or valleys.
Mounting above shiny surfaces:
On shiny surfaces, it is important that no direct reflection can get to the receiving optics. The reflection could
blind the sensor and produce poor results. To prevent this, the sensor may be slightly tilted. The direct
reflection can be seen on a white piece of paper when held in front of the receiver.
10 -15°
☺
Mounting above round, shiny surfaces:
☺
BA_OADM20I6_21I6_most.doc 34/87 Baumer
12.06.2017 Frauenfeld, Switzerland