EXIT Toys 12.92.06.02 Mode D'emploi page 17

STEP 5
1. Lay the frame Pad (6) on the frame.
Adjust the position of the Frame Pad so
that the slits are directly above the Socket,
as shown.
2. Thread the rope (9) through the hole
of the PAD and then through the closest
V-ring of trampoline mat (4). Secure the
end of the rope (9) by tying a knot around
both the net of the PAD and the V-ring.
Continue threading the rope (9) through
the next hole and the V-ring until all the
holes and V-rings have been threaded.
Make sure to pull the rope (9) tight when
threading.
Caution: Do not use the trampoline
without the Frame Pad (6). The Frame
Pad is designed to reduce the possibil-
ity of injuries due to jumpers coming
in contact with the trampoline frame.
If you do not have a Frame Pad, con-
tact
your dealer to obtain one. Properly
install the Frame Pad before using the
trampoline.
STEP 6
Look underneath the trampoline. Locate
the straps attached to the Feed the strap
(10) through the knot located the rear side
of the PAD, as shown. Now retrieve the
straps (10) attached to the underside of
the frame pad. Position each outer strap so
that one strap (10) is on each side of the
frame, as shown. Tie the outside straps
(10) that are sewn to the pad joints to
each side of the frame, as shown.
Repeat this step with the remaining straps
(not shown).
Notice: If you purchase the enclosure
please attach the mat and the net
together before attaching the strap to
the frame and V-rings.
Using the included plastic tie, attach the
warning label (8) to the frame near the
point where jumpers will climb onto and off
the trampoline.
5
6
1
Socket
2
hole
Toprail Frame
6
Frame
Knot
Outer Straps
(10)
Frame
Hole
Slit
Net of PAD (6)
Rope (9)
Backside PAD (6)
backside of the PAD
8
17