EXIT Toys 12.92.06.02 Mode D'emploi page 16

STEP 4
Caution: It is wise to wear
leather gloves while attaching
the Springs. Be careful where you
the Springs. Be careful where you
place your hands as the Springs
and frame joints can pinch.
First place 4 V-rings with blue color
of mat seperately on the both side of
the Socket and attach 4 springs at #1
and #2 to both mat and frame.
Then attach 2 springs at #3 and 2
springs at #4 in the same way. Make
sure to count the holes in the frame
and V-rings of the mat in the apropri-
ate position.
Contine to attach 2 springs at #5,
#6, until 12 springs have been at-
tached. Be sure to match the correct
mat ring to the correct frame hole.
After these springs have been at-
tached continue to attach all remain-
ing springs to the mat and frame in
any order.
Attach the Springs (5) as follows:
wing in next to the free end of the
Hook one end of a Spring (5) into a
V-ring sewn on the Jump mat. Hook
a Spring tool (7) shown as the inset
ame. Unhook the Spring tool.
drawing in next to the free end of the
Spring(5). Pull it by the spring tool(7)
until it reaches the frame. Push the
Note:The spring has a large hook
end of the Spring into a hole
in the frame. Unhook the Spring tool.
the first spring will be attached.
Note:The spring has a large hook
which attaches to the frame and a
small hook which attaches to the
mat ring.
Safety Notice:
as you attach Springs, carefully count
the V-rings and frame holes. If a V-
ring or a hole is skipped, reattach the
spring in the proper position.
WARNING!! : Please be careful where your hands and other parts of the
body are placed as the connector points and spring attachments can cre-
ate hand or body traps.
16
color of
ame.
the correct mat ring
ame hole. After these
y the spring tool(7)
4
#4
blue straps
socket
#5
socket
V-ring
5
socket
#1
blue straps
#6
blue straps
socket
#2
socket
4
7
Frame
Rahmen
Frame
Châssis
socket
#3