Télécharger Imprimer la page

Avintage AVU54TXDZA Notice D'utilisation page 43

Cave de service pose libre et encastrable sous plan
Masquer les pouces Voir aussi pour AVU54TXDZA:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-20°C
or 5-10°C/10-20°C (depending on the model).
• "RUN"
Power indicator
button
To turn the appliance on or off.
Press and hold this button for around 3 seconds.
button
Inner lighting control button
• Display
Upper chamber electronic display
• Display
Lower chamber electronic display
• Bouton
Upper chamber temperature setting button
• Bouton
Lower chamber temperature setting button
Press "
" to adjust the upper chamber temperature. The relevant chamber display will start to flash and
each press on the button will alter the temperature by 1°C. Once the lowest set temperature of 5°C is
reached, the display automatically changes to the highest set temperature of 10°C. Once selected, the
display will flash for approximately 5s before showing the current internal temperature of the cellar. The set
temperature can be viewed at any time by pressing and holding the temperature select buttons for 5s.
Press "
" to set the upper chamber temperature.. The relevant chamber display will start to flash and
each press on the button will alter the temperature by 1°C. Once the lowest set temperature of 10°C is
reached, the display automatically changes to the highest set temperature of 20°C. Once selected, the
display will flash for approximately 5s before showing the current internal temperature of the cellar. The set
temperature can be viewed at any time by pressing and holding the temperature select buttons for 5s.
In the event of a power cut, all previously selected temperature settings will be deleted and each chamber
will re-initialize to the factory-preset temperature of 6°C for the upper chamber and 12°C for the lower
chamber.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take
around 30 minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same
circumstance, it will take around 30 minutes to decrease the wine cooler's temperature from 12℃
to 5℃. The less the temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
43

Publicité

loading