Starting Your Lifebook Notebook; Power On - Fujitsu LifeBook A1120 Mode D'emploi

Starting Your LifeBook Notebook

Power On

Power/Suspend/Resume Button
The Power/Suspend/Resume button is used to turn on your LifeBook notebook from its off state. Once
you have connected your AC adapter or charged the internal Lithium ion battery, you can power on your
LifeBook notebook.
To turn on your LifeBook notebook from its off state, press the Power/Suspend/Resume button, located
above the keyboard to the right. When you are done working you can either leave your notebook in
Suspend mode (see "Sleep Mode" on page 47), or you can turn it off (see "Powering Off" on page 50).
When you power on your LifeBook, it will perform a Power On Self Test (POST) to check the internal
parts and configuration for correct functionality. If a fault is found, your LifeBook notebook will emit an
audio warning and/or an erro r message will be displayed. See "Power On Self T est Messages" on page 89.
Depending on the nature of the problem, you may be ab le to continue by starting the operating system or
by entering the BIOS setup utility and revising the settings.
After satisfactory completion of the POST, your notebook will load your operating system.
W
HEN YOU TURN ON YOUR
THAT A BATTERY IS INSTALLED AND CHARGED
CONNECTED AND HAS POWER
D L B
O NOT CARRY YOUR IFE
,
OR VIBRATION AS YOU RISK DAMAGING YOUR NOTEBOOK
41 - Starting Your LifeBook Notebook
L B ,
IFE OOK NOTEBOOK BE SURE YOU HAVE A POWER SOURCE
,
OR THAT THE
.
OOK NOTEBOOK AROUND WITH THE POWER ON OR SUBJECT IT TO SHOCKS
AC A /A
OR UTO IRLINE ADAPTER IS
.
. T
HIS MEANS