Citizen CT-S851 II Mode D'emploi page 63

Switch no. Function
MSW9-6 LCD Language
MSW9-7 LCD Ext. Char
MSW9-8 LCD Auto Off
MSW10-1 Print Density
MSW10-2 Print Speed
MSW10-3 ACK Timing
MSW10-4 Old Command
MSW10-5 Buzzer Event
MSW10-6 Buzzer Sound
MSW10-7 Key Lock
MSW10-8 LCD Direction
MSW13-1 Security/Target
MSW13-5 BT Device Scan
MSW13-6 Auto Reconnect
Notes:
*1: If print data is very dense, the print head is hot, data transmission is slow, or some other
conditions, the motor and printing may occasionally stop which causes white stripes in the
printout. To print high-density data, set MSW2-3 (Spool Print) to ON to reduce striping, although
this increases the time before printing starts.
For a serial interface, increase the transmission speed to prevent the motor from stopping.
*2: Black mark model
*3: The values for memory switches MSW7-X are only effective when DIP switch no. 1 is set to OFF .
Initial setting
English English, Français, Deutsch, Italiano, Español,
Japanese, Chinese
Valid Invalid, Valid
Never Never, 30seconds, 5minutes
100 % 70 %, 75 %, 80 %, 85 %, 90 %, 95 %, 100 %, 105 %,
110 %, 115 %, 120 %, 125 %, 130 %, 135 %, 140 %
Level 9 Level 1, Level 2, Level 3, Level 4, Level 5, Level 6,
Level 7 , Level 8, Level 9
Before Busy Before Busy, Same Period, After Busy
Invalid Invalid, CBM1, CBM2
Not by All Event/Error, Not by C.Open, Not by C.Open/PE
C.Open
Tone 2 Tone 1, Tone 2, Tone 3, Tone 4
Invalid Invalid, Valid
Normal Normal, Inverted
Low/All Low/All, Mid/All, Mid/Paired only, Hi/All, Hi/Paired
only
Discoverable No Response, Discoverable
Valid Invalid, Valid
— 59 —
Setting value