CHECK BATTERY CAPACITY
1. Press POWER (5) to turn on the booster MPB-8800 without any devices connected.
2. The battery capacity appears in the LCD display (1).
3. Turn off the booster MPB-8800, press POWER (5)
JUMP START A VEHICLE
1. Make sure the booster MPB-8800 is fully charged.
2. Turn off all accessories on the vehicle (radio, air conditioner, etc.)
3. Connect the jumper cable's RED clamp to the POSITIVE (+) post of the vehicle battery.
4. Connect the jumper cable's BLACK clamp to the NEGATIVE (-) post of the vehicle battery.
5. Insert the jumper cable connector into the 12 V connector (7) of the booster MPB-8800. Be sure the
connection is solid.
6. Press POWER (5) to turn on the booster MPB-8800.
7. Turn the vehicle ignition key for 3 seconds maximum.
If the vehicle starts:
• Disconnect the jumper cables from the MPB-8800 first (7), then disconnect the clamps from the
battery.
If the vehicle does not start:
• Wait 1 minute and try again.
8. Turn off the booster MPB-8800, press POWER (5)
CHARGING A 5 V USB DEVICE (TABLET, CELL PHONE, ETC.)
1. Press POWER (5) to turn on the booster MPB-8800.
2. Connect the USB plug of the 2-1 cable to the USB output (3) or (4) of the booster MPB-8800 according
to consuming of the device.
3. Connect your device to either the Mini USB or Micro USB inpout.
4. The MPB-8800 begins to charge your device, "OUT" and "5.0V 2.1A" or "5.0V 1.0A" appears in the
LCD display (1), according the used USB output.
5. It will turns off automatically at the end of the charge of the device.
TURN ON FLASHLIGHT
1. Press POWER (5) to turn on the booster MPB-8800.
2. Press and hold (3 seconds) POWER (5) to turn on the LED flashlight in steady mode.
3. Short press POWER (5) again to cycle through the 3 modes: Strobe S.O.S / Fast Strobe / Steady.
4. Press and hold POWER (5) to turn off the LED flashlight.
5. Turn off the booster MPB-8800, press POWER (5)
COMPACT TIRE INFLATOR
• This is not a toy. Please keep out of reach of children
• Do NOT leave the compressor unattended when in use
• Make sure to stay safe and away from traffic if you have to inflate tires at roadside
• Do not use the compressor in explosive atmospheres, in the presence of flammable liquids, gases or
dust
• Do not expose the compressor to rain or wet conditions
• In case of electrical or mechanical malfunction, immediately switch off the compressor and unplug it
• Over-inflation may cause items to burst which could cause injury. Do NOT attempt to over-inflate.
• The compact tire inflator cannot be serviced by the user.
This compact tire inflator is intended for short run use. Maximum running time should not
exceed 15 minutes and a 15 minute cool-down period is recommended before running the
compressor again.
12