Operation - Bartscher 150151 Mode D'emploi

Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
Do not disconnect the supply cable by pulling it, always pull the plug.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.2 Operation

•
Before the device operation clean it according to the instructions in
section 6 "Cleaning".
•
Place the motor block on the even and stable surface.
•
Put the blending tumbler on the motor block and rotate it clockwise to fix it (see below).
There are the following fixing possibilities:
for right hand
NOTE!
Keep in mind that after fixing the blending tumbler its handle must be
positioned in the front on the right or left side, as it is the only way to
assure contact with the sensor.
- 28 -
for left hand