Classic Accessories Colorado XTS Manuel De L'utilisateur page 15

C O L O R A D O X T S P O N T O O N B O A T O W N E R ' S M A N U A L
13. Insert the oar-locks.
Insert an oar-lock into the top of both oar-lock brackets on the pontoon frames.
There are three oar-lock positions; we suggest starting with the forward most
position. If you have the seat set back you may prefer the middle or back position.
Secure each oar-lock with an oar-lock clevis pin.
oar-stop
14. Set up the oars and oar-stops.
oar
First, assemble the two piece oars. Align the holes so that the button pops
through the oar handle.
To set an oar in an oar-lock, drop the blade of the oar into the oar-lock. Slide the
oar until the oart-stop rests against the oar-lock. The oart-stops are adjustable if
oar-stop
desired.
*Helpful Hint : Oars do not need to be taken apart in order to place in the
oar-locks.
ATTENTION
To Prevent Failure: Check and retighten all screws on both oar-locks before each
retighten all screws (2)
use with a Phillips screwdriver.
15. Attach the rod holder.
The rod holder may be placed in three different
positions on either the left or right pontoon
frame. You can hold your rod to the back (1), out
to the side (2) or to the front (3). The rod holder
attaches with the clevis frame pins as in step 8.
To use the rod holder first unwrap the rip-
and-grip strap on the end. Put your rod in the
holder butt end first then turn it to drop the reel
handle into the cutout on the side of the rod
holder. Keeping one hand on your rod use your
other hand to wrap the strap around the front
of the reel to secure your rod in place in the
holder.
You can purchase extra rod holders directly from
Classic Accessories customer service.
15