Front Panel Usb-C / Usb - i-tec U3CEXTEND22 Mode D'emploi

EN
INTRODUCTION
A simple USB hub that allows you to bring the internal USB 3.0 to
the front of your PC through a 3.5" panel. There are two USB 3.0 and
two USB-C ports available. The device allows you to use these ports
located on the front side of your computer so that you will never have
to look for USB 3.0 and USB-C ports at the back. All these ports have
a common maximum transfer rate of 5 Gb/sec. Driver installation is
not required for the front panel functionality. The front panel supports
Plug and Play as well as Hot Swap features.
HARDWARE INSTALLATION
1) Connect the USB 3.0 connector of the front panel to the USB 3.0 port
on the motherboard of your PC. The included 75 cm long USB 3.0 cable
is long enough to connect the motherboard to the front panel.
2) Connect the power part of the SATA cable to the front panel and
connect the other end to the power supply of your PC.
3) Finally, fix the metal frame using screws to the front 3.5" position
on the front side of the PC.
SOFTWARE INSTALLATION
Windows 8/8.1/10, macOS X and higher. It is necessary to have the
latest drivers for the USB 3.0 controller of the motherboard of your
PC installed.
PACKAGE CONTENTS
• i-tec 3.5" PC Front Panel (2x USB 3.0 + 2x USB-C)
• SATA cable (20 cm)
• 20-pin USB 3.0 cable (75 cm)
• Screws
• User Manual
SAFETY INSTRUCTIONS
• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping
and falling to the ground.
• Save the user manual for a possible use later.
6
Quick Start / Front Panel USB-C/USB 3.0