Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu LifeBook LH530 Guide D'utilisation

Memory Upgrade Module

Your Fujitsu LifeBook notebook comes with high speed Double Data Rate Synchronous Dynamic RAM
(DDR3-1066 SDRAM factory installed. The maximum amount of SDRAM that can be used in your system
is 4 GB (2 GB x 2)..If you do not have the maximum amount and would like to increase your notebook's
memory capacity, you may install an additional or larger memory upgrade modules. The memory upgrade
must be a dual-in-line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM
module only from the Fujitsu web store at www.shopfujitsu.com

Installing Memory Upgrade Modules

1
Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
2
Turn the notebook bottom side up, and remove the five screws from the memory upgrade module compartment
(Figure 28). Remove the cover.
3
Remove the new memory upgrade module from the static guarded sleeve.
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
.
UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
T
O MINIMIZE RISK TO THE MODULE
•
B
EFORE HANDLING A MEMORY MODULE
STATIC ELECTRICITY BUILT UP IN YOUR BODY
•
W
HEN INSTALLING OR REMOVING A MEMORY MODULE
TOUCH ANY CONTACTS OR CHIPS
TERMINALS OR COMPONENTS
.
COMPONENTS
•
B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
E
VEN IF THE SYSTEM IS IN HIBERNATE OR STANDBY STATES
MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
59 - Memory Upgrade Module
,
OBSERVE THE FOLLOWING PRECAUTIONS
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE
.
,
HOLD IT BY THE EDGE SO AS NOT TO
. B
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE
:
,
DATA COULD BE LOST OR THE
.
(ESD).
.