Care And Cleaning - AEG SKS68848F1 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

24 www.aeg.com

6. CARE AND CLEANING

CAUTION!
Unplug the appliance before car-
rying out any maintenance oper-
ation.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must
therefore only be carried out by
authorized technicians.
6.1 Periodic cleaning
The equipment has to be cleaned regu-
larly:
• clean the inside and accessories with
lukewarm water and some neutral
soap.
• regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
• rinse and dry thoroughly.
Do not pull, move or damage
any pipes and/or cables inside
the cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odour.
Take care of not to damage the
cooling system.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason it is recommended
that the outer casing of this appliance is
only cleaned with warm water with a little
washing-up liquid added.
After cleaning, reconnect the equipment
to the mains supply.
6.2 Defrosting of the
refrigerator
Frost is automatically eliminated from
the evaporator of the refrigerator com-
partment every time the motor compres-
sor stops, during normal use. The de-
frost water drains out through a trough
into a special container at the back of
the appliance, over the motor compres-
sor, where it evaporates.
It is important to periodically clean the
defrost water drain hole in the middle of
the refrigerator compartment channel to
prevent the water overflowing and drip-
ping onto the food inside. Use the spe-
cial cleaner provided, which you will find
already inserted into the drain hole.
6.3 Defrosting the freezer
A certain amount of frost will al-
ways form on the freezer shelves
and around the top compart-
ment.
Defrost the freezer when the
frost layer reaches a thickness of
about 3-5 mm.
To remove the frost, do these steps:
1.
Switch off the appliance.
2.
Remove any stored food, wrap it in
several layers of newspaper and put
it in a cool place.
3.
Leave the door open.
4.
When defrosting is completed, dry
the interior thoroughly and refit the
plug.
5.
Switch on the appliance.
6.
Set the temperature regulator to ob-
tain the maximum coldness and run

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Skse8840f1

Table des Matières